If you look at the Omnis 5.x Help and look for the “Register DLL” command in the upper right part it says “All Platforms” if you look in the Omnis 8.x Help it says only “Windows and Linux “.
In any case, if I try to type the command in the code, I will insert the letter R and the letter E, but the letter G cannot write it.
Do you have a Macintosh ?
Can you try on it ?
Thanks in advance.
Gianni
Ghiara Mimmo on 
Paul Mulroney on Paul Mulroney on Paul Mulroney on 
Rainer Greim on Paul Mulroney
Brian Germann
Jacques Couédor
JOHN DIDONE
Graeme Harris
© Omnis Software Ltd 2021 - Help with setup and design by Ädelfors Consult AB, Sweden Disclaimer: Omnis Software disclaims any responsibility for or liability related to Software, or any content or advice, obtained through this site. IN NO EVENT WILL OMNIS SOFTWARE BE LIABLE FOR ANY INDIRECT, PUNITIVE, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES HOWEVER THEY MAY ARISE AND EVEN IF OMNIS SOFTWARE HAS BEEN PREVIOUSLY ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
