Latest build v10.1 released (29237) problem dragging windows macOS

Hi Doug, it was the latter.

But I agree, it would be better if it could be effective upon the save
Do $root.$prefs.$setconfigjson(Row)

I’m sure that should be possible.

regards
Phil Potter
Based in Chester in the UK.

On 02/03/2021 16:04, Doug Easterbrook wrote:
>
> if you are asking:
>
> does the code below change the config.json for me:
>
> yes it does.
> — I cleared the parameter and then ran the code which created the
> parameters
> — I changed the parameter from true to false and back to true, both
> times checking the config.json.
>
>
> did it take effect right away?
>
> that I’m not sure.  I had the parameter as true before starting omnis,
> then I used omnis to change it to false.
> Omnis still behaved as if it were true.
>
> so I quit omnis and started again and all was fine.
>
>
> so, that makes me think omnis only loads parameters on startup, and
> not if you reset them under program control (so it becomes effective
> on next start).
>
>
> I have a question into tech support about that, with an enhancement
> request that if it does not reset omnis after doing a $setConfigJson,
> that could it please do that
>
>
> thats what I’ve found.   I’ve got it in place and I’ll know relatively
> soon as we migrate this version to people.
_____________________________________________________________
Manage your list subscriptions at lists.omnis-dev.com
Start a new message -> mailto:omnisdev-en@lists.omnis-dev.com